Cisco Systems PGW 2200 - page 178

3-14
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 3 Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
Text similar to the following is displayed:
For security reasons, ftp access is disabled by default.
Do you want to allow ftp access? (y/n) [N]
Step 6 If you want to allow ftp access, perform the following steps. If you do not want to allow ftp access, enter
n and press Enter, then proceed to Step 7.
a. Type y and press Enter.
Text similar to the following is displayed:
Allowing ftp access may pose a serious security risk.
Are you sure you want to allow ftp access? (y/n) [N]
b. Type y and press Enter to continue.
Text similar to the following is displayed:
For security reasons, telnet access is disabled by default.
Do you want to allow telnet access? (y/n) [N]
Step 7 If you want to allow telnet access, perform the following steps. If you do not want to allow telnet access,
enter n and press Enter, then proceed to Step 8.
a. Type y and press Enter.
Text similar to the following is displayed:
Allowing telnet access may pose a serious security risk.
Are you sure you want to allow telnet access? (y/n) [N]
b. Type y and press Enter to continue.
Text similar to the following is displayed:
For security reasons, the sudo command is disabled by default.
Do you want to enable sudo? (y/n) [N]
Step 8 If you want to enable Sudo, perform the following steps. If you do not want to enable Sudo, enter n and
press Enter, then proceed to Step 9.
a. Type y and press Enter.
Text similar to the following is displayed:
Enabling sudo may pose a serious security risk.
Are you sure you want to enable sudo? (y/n) [N]
b. Type y and press Enter to continue.
Text similar to the following is displayed:
The user will still need to edit the sudoers file
to allow specific users to run the command
Note To complete enabling Sudo, you must also complete the “Enabling Sudo” section after installing
the Cisco Security Package.
**************************************************
**************************************************
** **
** NOTE!! The machine must be REBOOTED in order **
** for these changes to take effect **
** **
**************************************************