Cisco Systems PGW 2200 Parameters Required for Initial Setup

4-7
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 4 Configuring the Cisco PGW 2200 Softswitch Software
Initial Cisco PGW 2200 Softswitch Software Configuration
Parameters Required for Initial Setup
The following table lists the parameter values that must be defined during the initial installation.
Note These parameters are located at the top of the XECfgParm.dat file, thus making it easier to find the
parameters required for initial setup.
engine.SysVirtualSwitch Indicates whether the Cisco PGW 2200 Softswitch host
functions as a signaling controller or a virtual switch
controller.
Valu es:
• 0—Signaling controller (nailed trunks, no auditing
is initiated)
• 1—Virtual switch controller (switched trunks)
Default: 0
Note During the startup of the
Cisco PGW 2200 Softswitch software, this
parameter is be set automatically to tune the
system for optimal performance.
Note For Release 9.4(1) and later, the values of the
parameters listed below are automatically set
based on the Cisco PGW 2200 Softswitch type
you select, to maximize performance for that
configuration. Any attempt to change the values
of these parameters is overwritten.
engine.SysMdlMemoryReduction
engine.CALL_MEM_BLOCK_SIZE
engine.CALL_MEM_CHUNK_SIZE
*.CPUTimerInterval
*.numberOfThreads
pom.dataSync Indicates that the Provisioning Object Manager (POM)
should synchronize the provisioning data at startup.
Valu es:
• True— POM does not synchronize provisioning
data at startup.
• False— POM synchronizes provisioning data at
startup.
Default: False
Table 4-3 Configuration Parameters (continued)
Parameter Description