2-77
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 2 Installing the Sun Solaris 10 Operating System
Loading the Sun Solaris 10 Operating Environment
not indicate a problem. Please look at the log file
after the rest of the patches are applied
Install Solaris 10 patches from set 2 ...
Changed to /var/tmp directory
*** InstallPatches10 ends Tue Jul 8 11:14:41 GMT+8 2008 ***
*************************************************
* It is necessary to reboot this machine *
* for these patches to be incorporated *
* the operating system. Enter the following *
* command and press Enter: reboot -- -r *
*************************************************
Step 5 Type the following command and press Enter to reboot the target machine.
#reboot -- -r
Note If you used the CD-ROM drive to load the Solaris 10 patch cluster, eject the CD prior to
rebooting.
Note If you have installed the Solaris DiskSuite package (CSCOh023) on your system, the messages
below are displayed during system boot. They are normal Solaris DiskSuite startup messages
and do not indicate any problem with your system.
WARNING force load of misc /md-trans failed
WARNING force load of misc /md-raid failed
WARNING force load of misc /md-hotspares failed
WARNING force load of misc /md-sp failed
This completes the procedures for installing the Solaris 10 patches for Opteron-based platforms. Go to
Table 2-2 on page 2-72 if you want to continue with the list for package installation. If you have
questions or need assistance, see the “Obtaining Documentation and Submitting a Service Request”
section on page x.
Installing the Solstice DiskSuite (CSCOh023)
The Sun Solstice DiskSuite program enables you to use the second disk drive as a mirror of the first to
increase the availability of the system.You can install the DiskSuite program by running the scripts
described below. The machine reboots several times during the installation process. The scripts minimize
the possibility of running the scripts in the wrong order. However, you should ensure that the program
is properly installed and take reasonable precautions to run the scripts correctly.
Note You must log in as root to run the following DiskSuite installation script.
Note For Sun Fire X4600 and Sun Netra X4200 M2 platforms, do not change the default hard disk boot order
in the BIOS settings. If the primary disk is changed from the default of c3t0d0, the DiskSuite installation
fails.