Cisco Systems RVS4000RF manual Configuration When Both Gateways Use Dynamic IP Addresses

Gateway-to-Gateway VPN Tunnel

Configuration When Both Gateways Use Dynamic IP Addresses

D

Configuration When Both Gateways Use Dynamic IP Addresses

This example assumes both Gateways are using dynamic IP addresses. If only the Remote Gateway uses a dynamic IP address, refer to “Configuration when the Remote Gateway Uses a Dynamic IP Address,” on page 172.

Gateway-to-Gateway IPSec VPN Tunnel - Both Gateways Using

Dynamic IP

NOTE Each computer must have a network adapter installed.

STEP 1 Configuration of the RVS4000.

Follow these instructions for the first VPN router, designated RVS4000. The other VPN router is designated the RV082.

a.Launch the web browser for a networked computer, designated PC 1.

b.Access the configuration utility of the RVS4000. (Refer to Chapter 5, “Setting Up and Configuring the Router” for details.)

c.Click VPN > IPSec VPN.

d.Enter a name in the Tunnel Name field.

e.For the IPSec VPN Tunnel setting, select Enable.

f.The WAN IP address (A.A.A.A) of the RVS4000 will be automatically detected.

Cisco RVS4000 Security Router with VPN Administrator Guide 177