1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 4 of 4
Table 792-2. T3 CES Interface Configuration Options
SELECTION
Interface Name
ATM VPI
ATM VCI
Operational State
Buffer Maximum Size
Cell Arrival Jitter Tolerance
CBR Clock Mode
DEFAULT | OPTIONS |
| User Defined |
|
|
<user | |
defined> |
|
|
|
<user | |
defined> |
|
|
|
Up | Up |
| Down |
| Unknown |
|
|
1600 | 1500 to 2000 |
|
|
800 | 750 to 1000 |
|
|
Adaptive | Adaptive |
| Synchronous |
| SRTS |
|
|
DEFINITIONS
Can be used to assign a name to the port or use the system default.
This is a read only to show the available bits configured for this port during connection creation.
This is a read only to show the available bits configured for this port during connection creation.
Display only. State of the interface port is Up and available for service, Down due to a problem, or Unknown due to communication error.
Maximum size measured in microseconds and selectable in 10 microsecond increments.
Maximum size measured in microseconds and selectable in 10 microsecond increments.
Sets the Constant Bit Rate clock to adapt to the incoming bit stream, look for a constant synchronous bit stream, or Synchronous Residual Time Stamp used for recovering clock signals in a packet system (ATM).
Page
© 2000, ADC Telecommunications, Inc.
