ADC Release 3.1 user manual Retrieve 155 Ring Card Status, Ring Card Status Display

1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance

DLP-763

Page 1 of 3

RETRIEVE 155 RING CARD STATUS

Summary: This procedure defines the information retrieved from the shelf level GUI display for the 155 Ring card status. User must have the GUI launched and accessed the shelf level GUI display per NTP-007 prior to performing this procedure.

1.Double click on the 155 Ring card located in the shelf level GUI “Chassis View” at the top of the window. These should be in slots 16 and 17.

2.The 155 Ring card display appears as shown in Figure 763-1. Click the small block between the Status and Configuration sections and drag it downward to view all the status information. Refer to Table 763-1 for definitions of status information provided.

Stop! You have completed this procedure.

Cellworx Vision:	Card View - 155 Ring Interface Card			X
NE Name: Cellworx1	Status:
NE Id: 16	Card Level
Card: 155 Ring	Operational State:	Up
Slot Number: 16
	Availability State:	Available
Port Number: 1	Protection State:	Not Protected
155	Port Level
Ring
	Section Status:	Line Status:	Path Status:
	No Alarm	No Alarm	No Alarm
	LOS	AIS	STS LOP
	LOF	RDI	STS AIS
			STS RDI
			Unequipped
			Signal Label
ADC			Mismatch
Status	Synachronization Status: ST3
Active	TC Alarm Status:	No Alarm
Timing	Recieve Path Trace: NE15 Slot 16 Port1 (OC3)			CLICK ON BOX AND DRAG
Port
				UP OR DOWN TO EXPAND
1
				STATUS OR CONFIGURATION
				VIEWS.
	Configuration:
	Port Level

Apply Chassis View Diagnostics Refresh Close

APPLIES CHANGES	RETURNS TO CHASSIS	PERFORMS TEST	REPAINTS WINDOW	CLOSES CARD LEVEL
AND SENDS TO SHELF	VIEW WITHOUT CLOSING	OVER FIBER	TO REFLECT ANY	VIEW AND RETURNS TO
CONTROLLER.	CARD LEVEL VIEW.	LINK.	CHANGES.	SHELF LEVEL VIEW.	0026-052

Figure 763-1. 155 Ring Card Status Display

Page 2-281

© 2000, ADC Telecommunications, Inc.