1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance
DLP-702
Page 3 of 5
7.The last two text lines must be removed from the /etc/hosts file. This step has already been performed before NMIC shipment. If this is the first time the IP address is being changed, skip this entire step and proceed to step 8. If the IP address has been changed previously, continue with the following steps.
a.On the NMIC, type “cd /etc” to go to the etc directory.
b.Make a copy of the hosts file for backup by typing “cp hosts hosts.backup”.
c.Type in “export TERM=vt100”.
d.Using the vi editor on the NMIC edit the hosts file. To activate the vi editor with this file type “vi hosts”.
e.In the editor, go to the bottom of the file by holding down the shift key and typing g (shift+g).
f.The last two text lines of this file must be deleted. The keyword to look for is “EactiveNMIC” in the last line. The two lines will look similar to the following:
155.226.39.28 WS03928
155.226.39.27 EactiveNmic
g.To delete these last two lines, and type “2dd”.
h.Save the file by typing “:x” in the editor followed by an enter.
8.Type “cd /sbin” to go to the sbin directory.
Note: : The user should make a backup of the /etc/hosts if not already done.
9.Type “./cw_netcfg” to execute the cw_netcfg script. This script will prompt the user to enter various IP addresses and IP masks to be changed as defined in Table
Note: DO NOT USE THE BACKSPACE KEY TO EDIT ON THE COMMAND LINE WHEN ENTERING INFORMATION. Doing so may insert
Page
© 2000, ADC Telecommunications, Inc.
