1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
SELECTION
Page 3 of 5
Table 747-1. E1 Multi 1 Configuration Options
| DEFAULT |
| OPTIONS |
| DEFINITIONS |
|
|
|
|
|
|
|
|
Card and Port Administrative State
Ingress/Egress
Congestion
Threshold
Ring Selection
Transmit Timing Source
Service Type
Line Build Out
Line Coding
Line Type
Loopback. Config
Circuit Identifier
Interface Name
Loopback Location Code
Recording Interface
ID
Provisioned
Endpoints
Interface Type
CAC Formula
Unlocked
80
Auto
Local
CRS
120 Ohms
HDB3
E1
MF
None
<blank>
<default>
All 1s
All 0s
0
UNI
PCR
Unlocked
Locked
Auto
Ring 16
Ring 17
Received
Local
CES
CRS
75Ohms
120Ohms
HDB3
E1
MF
None
Terminal
Facility Line
Up to 20 alphanumeric characters.
Alphanumeric
Alphanumeric
Numeric
User cannot configure.
UNI
NNI
PCR
SCR
Enables or disables card or port for service, respectively.
Percentage of ingress or egress buffer capacity that will cause a congestion threshold notification.
Card will automatically select traffic from the ring direction with the best signal.
Card will receive traffic from Ring 16 direction. Card will receive traffic from Ring 17 direction.
Incoming clock pulse used for outgoing signal.
Clock pulse supplied by the SC cards used for outgoing signal.
Circuit Emulation Service.
Cell Relay Service.
Sets the signal strength according to the distance in feet that the Cellworx STN is from the E1 interfacing equipment.
European Standard, non configurable.
Sets the line type to reflect customer equipment. Must be set in groups of 8 ports
No loopback activated on this card.
Sends cells to the cellbus and back to the ring. No changes are made to the path layer data.
Loops the incoming signal back to CPE, generates AIS to the cellbus.
User defined. Usually describes the traffic, customer, and/or channel number.
User defined, up to 20 alpha numeric characters
Used to loopback the incoming signal and transmit it back to the customer equipment, limited to 16 numeric characters.
Identifies the site card and port location for customer billing capabilities, (allows assignment of a customer ID for each port), limited to 15 numeric characters.
Displays how many VPC or VCC endpoints are configured by administrator on this card.
Specifies interface type as User to Network Interface or Network to Network Interface.
Specifies Peak Cell Rate or Sustained Cell Rate for Connection Admission Control.
(continued)
Page
© 2000, ADC Telecommunications, Inc.
