ADC Release 3.1 user manual Retrieve FE1 FRS Card Status, FE1 FRS Card Status Window

1152700 • Issue 1 • February 2001 • Operation and Maintenance

DLP-789

Page 1 of 3

RETRIEVE FE1 FRS CARD STATUS

Summary: This procedure defines the information retrieved from the shelf level GUI display for the FE1 FRS card status. User must have the GUI launched and accessed the shelf level GUI display per NTP-007 prior to performing this procedure.

1.Double click on the FE1 FRS card located in the shelf level GUI “Chassis View” at the top of the window.

2.The FE1 FRS card display appears as shown in Figure 789-1. Click the small block between the Status and Configuration sections and drag it downward to view all the status information. Refer to Table 789-1 for definitions of status information provided.

3.Select each port on the card to view the port status.

4.Select Close button to return to the chassis level view.

Stop! You have completed this procedure.

Cellworx Vision:	Card View - FE1 Frame Relay Service		X
NE Name: Cellworx1	Status:
NE Id: 21	Card Level
Card: FE1 FRS	Operational State:	Up
Slot Number: 13
	Availability State:	Available
Port Number: 1
	Protection State:	Not Protected
FE1	Port Level
FRS
	Line State:
	Recieve:	Transmit:
	No Alarm	XMT Far End LOF
	RCV Far End LOF	XMT AIS
	RCV AIS	XMT Far End LOMF
	RCV Far End LOMF
	RCV Test Code
ADC	Other:
Status	LOF
	LOS
Active
APS	Loopback State
Port	Other Failure
1
2
3
4
5
6	Configuration:
7
8
	Port Level
Apply	Chassis View	Refresh	Close

CLICK ON BOX AND DRAG UP OR DOWN TO EXPAND STATUS OR CONFIGURATION VIEWS.

APPLIES CHANGES	RETURNS TO CHASSIS	REPAINTS WINDOW	CLOSES CARD LEVEL
AND SENDS TO SHELF	VIEW WITHOUT CLOSING	TO REFLECT ANY	VIEW AND RETURNS TO
CONTROLLER.	CARD LEVEL VIEW.	CHANGES.	SHELF LEVEL VIEW.	0026-010

Figure 789-1. FE1 FRS Card Status Window

Page 2-389

© 2000, ADC Telecommunications, Inc.