1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 4 of 5
Table 747-2. ATM Interface Configuration Options for CRS Mode
SELECTION
Policing
Cell Scrambling
Over Subscription Rate
Max Active VPI Bits
Max Active VCI Bits
Max number of VPCs
Max number of VCCs
DEFAULT
Off
On
100
0
10
1
0
OPTIONS
On or Off
On or Off
0 to 10
0 to 256
0 to 256
DEFINITIONS
User sets whether traffic will be policed for Quality Of Service (QOS).
User sets whether traffic will be scrambled.
User sets percentage depending on traffic contract.
Sets the maximum number of bits allowed may be utilized from this port.
Sets the maximum number of bits allowed may be utilized from this port.
Sets the maximum number of VPCs that may be utilized from this port.
Sets the maximum number of VCCs that may be utilized from this port.
SELECTION
Table 747-3. E1 Multi 1 Configuration Options for CES Mode
| DEFAULT |
| OPTIONS |
| DEFINITIONS |
|
|
|
|
|
|
Interface Name
ATM VPI
ATM VCI
Operational State
Buffer Maximum Size
Cell Arrival Jitter Tolerance
CBR Clock Mode
<default>
<user
defined>
<user
defined>
Up
6220
1040
Adaptive
Alphanumeric
Up/Down
5300 to 6220
950 to 2650
Adaptive,
Synchronous, or SRTS
User defined, up to 20 alpha numeric characters.
This is a read only to show the available bits configured for this port during connection creation.
This is a read only to show the available bits configured for this port during connection creation.
This is a read only to show the state of the port.
Maximum size measured in microseconds and selectable in 10 microsecond increments.
Maximum size measured in microseconds and selectable in 10 microsecond increments.
Sets the Constant Bit Rate clock to either adapt to the incoming bit stream or look for a constant synchronous bit stream.
Page
© 2000, ADC Telecommunications, Inc.