FE1 FRS Card Configuration Options, Frs

1152700 • Issue 1 • February 2001 • Operation and Maintenance

Page 5 of 7

Table 784-2. FE1 FRS Card Configuration Options

	OPTIONS	DEFINITIONS
	Unlocked	Enables or disables card/port for service,
	Locked	respectively.

0-100		Percentage of ingress/egress buffer capacity that will
		cause a congestion threshold notification.
	Auto	Card will automatically select traffic from the ring
		direction with the best signal.
	Ring 16	Card will receive traffic from Ring 16 direction.
	Ring 17	Card will receive traffic from Ring 17 direction.
	Variable	This will cause the FECN/BECN in the frame relay
		header to be set or cleared. Abatement is always ten
		percent less than onset.
	Variable	Exceeding threshold causes frames with DE field
		equal to 1 to be discarded. Frame discarding stops
		upon reaching abatement level. Abatement is always
		ten percent less than onset.

Received

Local

FRS

120 Ohms

E1 CRC-4

Up to 20 alphanumeric characters.

None

Facility Line

Terminal

Facility Payload

N/A

Incoming clock pulse used for outgoing signal.

Clock pulse supplied by the SC cards used for outgoing signal.

Frame Relay Service.

Sets the signal strength according to the distance in feet that the Cellworx STN is from the E1 interfacing equipment, not user configurable.

European Standard, not user configurable.

User defined. Usually describes the traffic, customer, and/or channel number.

No Loopback selected.

Loops frames back out to EIM.

Loops ATM cells back to Cellbus.

Not user selectable on FE1 FRS interfaces.

Page 2-354