1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 2 of 3
ITEM
CARD
Table 759-1. 622 RIC Card Status Definitions
| STATUS |
| DEFINITION |
| ACTION |
|
|
|
|
|
|
Operational State
Availability State
PORT
Section
Status
Line Status
Up
Down
Unknown
Available
In Test
Failed
PowerOff
Not Installed
Offline
Dependency
Unknown
No Alarm
LOS
LOF
No Alarm
AIS
RDI
Card is functioning properly.
Card is not functioning properly, is in reset mode, or failed. Check Admin state.
The system processor does not currently know the operational status.
Card is ready for processing commands.
Card is currently processing test signals.
Card has failed operation and system has placed it out of service.
No power to the card.
Card is not installed.
Card is installed and provisioned but currently off line.
Card is supplying timing reference, traffic, or other data to the system.
The system processor does not currently know the availability status.
No errors between local and next node.
Loss Of Signal (cannot locate section data)
Loss Of Frame (cannot locate frame bit of section data)
Receiving good input signal
Alarm Indication Signal, inserted all 1s or blue signal at originating node.
Remote Defect Indicator. Far end sending indication that it is receiving a defective signal.
No action required.
Verify card is installed,
check for failure indications or provision card for service per DLP- 751.
Wait a few seconds for system to complete its operations and then refresh the screen.
No action required.
Wait a few seconds for screen to update.
Card may be performing a reset, or the bus may be busy.
Check power source. Replace card if source is good per
If required, install card in selected slot per
If required, set module on line per
Perform a soft switch over (manual) per
Wait for processor to update current status, may need to perform a manual reset of SC per
No action required.
Check connectors, fiber, and transmitter at other end.
Check signal type, and power level of received signal.
No action required.
Check signal status at traversing nodes, and low speed signal input at transmitting node.
Check local transmitting end signal for defects.
(continued)
Page
© 2000, ADC Telecommunications, Inc.
