ADCP-70-220 Issue 1 November 2000 Section 2 Operation and Maintenance

NTP-006

Page 1 of 5

PROVISION NODE PARAMETERS

Summary: This procedure outlines the steps required to assign operational and administrative parameters within each node such as Node ID, port addresses, card configurations, etc., using the shelf level Graphical User Interface (GUI) available with Phase 3.1 software. This procedure is divided into the following headings:

A.Shelf Parameters

B.Card Configurations

C.Card Performance Monitoring Parameters Pre-requisites to this procedure are:

User must be logged into the system and have GUI launched

Node to be provisioned must be Discovered and visible to the GUI

Note: In a 19-inch shelf, slot 12 through 15 will always show up as “grayed out” and the last three slots will always be treated as slots 16, 17, and 18 even though there are physically only 14 slots available.

A. SHELF PARAMETERS

1.From the GUI main window, double click on the node to be provisioned using the left mouse button. This will launch a session with the node producing a chassis view similar to the one shown in Figure 006-1.

Page 2-14

© 2000, ADC Telecommunications, Inc.

Page 44
Image 44
ADC Release 3.1 user manual Provision Node Parameters, Shelf Parameters