
1152700 • Issue 1 • February 2001 • Operation and Maintenance
Page 2 of 3
ITEM
Table 789-1. Display FE1 FRS Card Status Definitions
| STATUS |
| DEFINITION |
| ACTION |
|
|
|
|
|
|
|
|
Operational State
Availability State
Protection State
Up
Down
Unknown
Available
In Test
Failed
Power Off
Not Installed
Off Line
Dependency
Unknown
Not
Protected
Card is functioning properly.
Card is not functioning properly, is in reset mode, or failed. Check Admin state.
The shelf controller does not currently know the operational status.
Card is ready for processing commands.
Card is currently processing test signals.
Card has failed operation and system has placed it out of service.
No power to the card.
Card is not currently installed in selected slot of the shelf.
Card is installed and provisioned but currently off line.
Card is supplying timing reference, traffic, or other data to the system.
The system processor does not currently know the availability status.
Not Protected
No action required.
Verify card is installed, check for failure indications, or provision card for service per
Wait a few seconds for operations to complete and update the screen.
No action required.
Wait a few seconds for screen to update.
Card may be performing a reset, or the bus may be busy.
Check power source, replace card if source is good per
If required, install card in selected slot per
If required, set module on line per DLP- 784.
Perform a soft switch over (manual) per
Wait for processor to update current status, may need to perform a manual reset of SC per
Protection operation on FRS cards is not available with release 3.1 software.
(continued)
Page
© 2000, ADC Telecommunications, Inc.