1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance
Page 5 of 7
Table
SELECTION
Facility Data Link
Circuit Identifier
Line Coding
DEFAULT
None
<blank>
AMI
OPTIONS
None
ANSI T1-403 FDL
Any alphanumeric characters, up to 20?
AMI
DEFINITIONS
A
User defined. Usually describes the traffic, customer, and/or channel number.
Alternate Mark Inversion format. Not selectable by user.
Table 754-3. ATM Interface Configuration Options for CRS Mode
SELECTION
DEFAULT
OPTIONS
DEFINITIONS
Interface Name
Loopback Location Code
Recording Interface ID
Provisioned Endpoints
Interface Type
CAC Formula
Policing
Cell Scrambling
Over Subscription Rate
Max Active VPI Bits
Max Active VCI Bits
Max number of VPCs
Max number of VCCs
<default>
All 1s
All 0s
UNI
PCR
Off
Off
<blank>
0
0
4096
0
Alphanumeric
Alphanumeric
Numeric
UNI
NNI
PCR
SCR
On or Off
On or Off
0to 8
0 to 12
0 to 256
User defined, up to 20 alphanumeric characters.
Used to loopback the incoming signal and transmit it back to the customer equipment. The code is limited to 16 numeric characters.
Identifies the site card and port location for customer billing capabilities, (allows assignment of a customer ID for each port.) The code is limited to 15 numeric characters.
Displays how many VPC or VCC endpoints are configured by administrator on this card.
Specifies interface type as User to Network Interface or Network to Network Interface.
Specifies Peak Cell Rate or Sustained Cell Rate for Connection Admission Control.
User sets whether traffic will be policed for Quality Of Service (QOS).
User sets whether traffic will be scrambled.
User sets depending on traffic contract.
Sets the maximum number of bits that may be utilized from this port.
Sets the maximum number of bits that may be utilized from this port.
Sets the maximum number of VPCs that may be utilized from this port.
Sets the maximum number of VCCs that may be utilized from this port.
Page
© 2000, ADC Telecommunications, Inc.
