1152700Issue 1 February 2001 Section 2 Operations and Maintenance

TAP-100

Page 7 of 23

Table 4-1. Alarm Identifications, continued

ALARM MESSAGE

 

SEVERITY

 

IMPACT

 

 

 

 

 

 

 

 

 

DESCRIPTION

 

SUGGESTED COURSE OF ACTION

 

 

 

 

 

 

 

 

Discard

Header

Error

Count

Violation

Threshold

Crossing

Alert

DiscardHec VioThresho ldExceeded

EIM Removed

Egress

Congestion

High

Threshold

Crossing

Alert

EgressCong estHighTca

Endpoint

Alarm

Indication

Signal

EndpointAI

S

Information

Service

al Alert

Degradation

 

 

Information

Service

al Alert

Degradation

Information

Service

al Alert

Degradation

 

 

Minor

Service

 

Affecting

 

 

Cells discarded due to Header Error Checksum have crossed the user definable threshold setting causing a Threshold crossing alert (TCA).

EIM has physically been pulled from the backplane.

Cells congested on the egress of reported port have crossed a user definable threshold level.

Endpoint of reported connection is receiving AIS code due to a failure somewhere in the connection path.

Could be caused by a port failure at any ATM interface. Verify the port is online, check configuration, look for indications of high BER (Bit Error Rate), increase threshold settings if necessary, use line loopback to troubleshoot path through port.

Install EIM card as needed.

Review traffic contracts and modify threshold level if needed. Monitor for future congestion alarms. Cells tagged for discard become susceptible to termination.

Check connection originating point by retrieving connection status and using OAM loopback from test equipment. Check input at the Electrical Interface Module (EIM) and the facility status on the Access Interface Card (AIC).

Endpoint

Minor

Service

Loss of

 

Affecting

Clock

 

 

EndpointL

 

 

OC

 

 

Endpoint

Minor

Service

Remote

 

Affecting

Defect

 

 

Indication

 

 

EndpointR

 

 

DI

 

 

No ATM cell traffic is present at connection endpoint.

Endpoint remote defect indication. AIS is detected by the remote endpoint causing an RDI.

Perform ATM loopback to verify path continuity through port.

Check the AIC and EIM that feed the traffic for the connection.

Page 2-426

© 2000, ADC Telecommunications, Inc.

(continued)

Page 470
Image 470
ADC Release 3.1 EIM Removed Egress Congestion High Threshold Crossing Alert, Endpoint Alarm Indication Signal, Loss, Clock