ADC Release 3.1 SET E1 Multi 1 Card Configuration, ATM Interface Configuration CRS Mode

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance

DLP-747

Page 1 of 5

SET E1 MULTI 1 CARD CONFIGURATION

Summary: This procedure details the steps required to set the E1 Multi 1 card configurations utilizing the Cellworx STN Phase 3.1 shelf level Graphical User Interface (GUI). User must have the GUI launched, and have accessed the shelf level GUI display per NTP-006 prior to performing this procedure.

1.Double click on the E1 Multi 1 card displayed in the shelf level GUI “Chassis View”at the top of the window. The E1 Multi 1 card display appears as shown in Figure 747-1.

2.Click and drag the small block upward to expand the Configuration section of the window so all or most options are visible. The Administrative State of the card and port should be “Unlocked” if in service. If “Locked”, select the “Unlocked” option using the left mouse button to enable the card and/or port for service.

3.Select a Port on the simulated card by a single click using the left mouse button.

4.Set the Port Level configuration options per requirements. Refer to Table 747-1 for a list of options the user may select for this card type.

5.Hit the Apply button at the bottom of the window to back up the new configuration data to the shelf controller.

Note: Selecting Chassis View will return the user to the previous window without closing the E1 Multi 1 window. Selecting Refresh will update the current window display with all the selections last recorded by the Shelf Controller card. Selecting Close will close this window and return the user to the Chassis View window.

6.If configuring the port for Cell Relay Service, continue with step 7. If configuring the port for Circuit Emulation Service, go to step 13.

B. ATM INTERFACE CONFIGURATION (CRS MODE)

7.Double click on one of the ports available (1 to 16). The ATM interface screen appears. Refer to the example shown in Figure 747-2.

8.Set the ATM configuration options as needed. Table 747-2 shows a list of options the user may select.

9.Select the Close button to return to the E1 card display.

10.Repeat steps 3 through 6 for each E1 Multi 1 port on the card.

11.Select the Close button to return to the Chassis View window.

12.Repeat steps 1 through 11 for each card in the shelf.

Page 2-221

© 2000, ADC Telecommunications, Inc.