ADC Release 3.1 user manual Default Options Definition

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance

Page 2 of 3

DLP-751

NE AND CARD TYPE/ SLOT INFORMATION.

CARD REPRESENTATION WITH REAL-TIME ALARM INDICATIONS.

	Cellworx Vision:	Card View - 622 Ring Interface Card									X
			Status:
NE Name: Cellworx1
NE Id: 1
Card: 622 Ring			Configuration:
Slot Number: 17
				Card Level
Port Number: 1
				Administrative State:		Congestion Thresholds:
				Locked			Ingress:		80	%
	622			Unlocked			Egress:			%
	Ring								80
				Ring Selection :
				Auto	Ring 16			Ring 17
				Port Level
				Administrative State:			Transmit Timing Source:
				Locked				System
	ADC			Unlocked				Recieved
	Status			Do not use for synchronization
	Active			Enable signal degrade
	Protect			Signal Degrade BER Threshold: 10E-					5
	Timing			Medium Type:
	Port
	1			SONET	SDH
				Loopback towards:
				None	Terminal			Facility
				Line Coding:		sonetMediumNRZ
				Line Type:		sonetLongSingleMode

Apply Chassis View Diagnostics Refresh Close

CLICK ON BOX AND DRAG UP OR DOWN TO WIDEN STATUS OR CONFIGURATION VIEWS.

CARD LEVEL CONFIGURATION OPTIONS.

CLICK ON BOX AND DRAG UP OR DOWN TO WIDEN PORT LEVEL VIEW.

622 MBPS PORT LEVEL CONFIGURATION OPTIONS.

USE SLIDERS TO VIEW

HIDDEN SELECTIONS.

APPLIES CHANGES	RETURNS TO CHASSIS	PERFORMS TEST	REPAINTS WINDOW	CLOSES CARD LEVEL
AND SENDS TO SHELF	VIEW WITHOUT CLOSING	OVER FIBER	TO REFLECT ANY	VIEW AND RETURNS TO
CONTROLLER.	CARD LEVEL VIEW.	LINK.	CHANGES.	SHELF LEVEL VIEW.	13443-B

SELECTION

Figure 751-1. 622 RIC Shelf Level GUI Configuration Screen

Table 751-1. 622 RIC Card Configuration Options

DEFAULT OPTIONS DEFINITION

Admin State

Congestion Threshold

Ring

Selection

Transmit

Timing

Source

Do Not Use for Sync

Enable Signal Degrade

Unlock

80

Auto

System

False

Not Selected

N/A

0-100

N/A

System

Received

Selected (true)

Not selected (false)

Selected

Not Selected

Not Configurable on RIC

Percentage of buffer capacity that will cause a congestion threshold notification for Ingress and Egress.

Not Configurable on RIC

Uses Primary timing reference.

Uses clock derived from incoming receive fiber (also known as Line-Timing).

If “True”, causes the RIC to output DUS (Do not Use for Sync) in the S1 byte of the SONET overhead.

Enables a protection switch of the traffic if the input signal strength drops below tolerable levels set by the user in the BER threshold selection.

(continued)

Page 2-235

© 2000, ADC Telecommunications, Inc.