ADC Release 3.1 user manual 10966-E

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance

DLP-737

Page 3 of 8

15.The system now attempts to verify the new NE is connected correctly over both ring directions, indicated by the pointer on step 15 of the Task Overview window. The “Discovering Network” message window appears as shown in Figure 737-12. Discovery verifies the physical connectivity between the nodes and should take less than ten seconds.

16.The system now restores all traffic across both ring directions through the new NE. Subsequently, the “Add NE” task is complete and the topology is updated as per step 17 of the Task Overview window. The system responds with a message window indicating that it is updating the network topology and to please wait. Refer to Figure 737-14.

18.The user will be prompted to save the new icon layout. Refer to Figure 737-15. To do this, select the disk icon on the tool bar above the work area or select the File pull down menu and Save Icon Layout or by entering Alt+F followed by an Alt+S on the keyboard. Refer to Figure 737-16.

19.The user may now provision the new node per NTP-006.

Stop! You have completed this procedure.

Cellworx Vision Subnetwork Management System

File

Configuration

Fault Performance

Time and Date

Connection

Topology

Software

NMIC Platform

Add Ring Network Element

Add Expansion Shelf Network Element

Remove Ring Network Element

Remove Expansion Shelf Network Element

Refresh...

Force Network Discovery ...

Revert to Saved Icon Layout...

Ring Audit

Ring Upgrade

Turn Up Ring...

10966-E

Figure 737-1. Cellworx Vision Configuration Pull Down Menu

Page 2-186

2000, ADC Telecommunications, Inc.