ADC Release 3.1 user manual Create AN ATM or CES Connection

1152700 • Issue 1 • February 2001 • Section 2 Operations and Maintenance

DLP-708

Page 1 of 7

CREATE AN ATM OR CES CONNECTION

Summary: This procedure describes the steps required to provision a UBR, CBR or VBR connection through the Cellworx STN network. Creating a connection entails selecting the originating and terminating NEs, cards, ports, specifying whether the connections are VP, VC, CES, UNI, NNI, or a combination of and assigning identifiers and traffic contract types. For Frame Relay connections refer to DLP-786, for ATM Multicast connections, refer to DLP-787, and for ATM Bundled VC Multicast connections, refer to DLP-790. Traffic contracts will be discussed in this procedure but performed elsewhere. Prerequisites of establishing a connection are:

•A discovery must have been performed on the system.

•The connection endpoints hardware (cards/ports) must be provisioned and in service (unlocked) per NTP-006.

Note: User may navigate through the GUI menus using the mouse or by using the Alt key plus the underlined letters in the menus simultaneously, and then the arrow keys to scroll up, down, or across. Refer to the Graphical User Interface Operation in Section 2 of this document.

1.There are three ways to initiate the process of establishing a connection.

a.Using the left mouse button, select the Configuration pull-down menu, click on Connection, and then Create (or press Alt+C, Alt+N, Alt+C.) Refer to Figure 708-1.

b.Using the Select tool (arrow) on the left toolbar, select the NE where the connection is originating by a click and hold on the right mouse button. A pop-up window appears as shown in Figure 708-1. Continue holding down the right mouse button and move the cursor to select Create Connection. Release the mouse button.

c.Using the left mouse button, select the connection tool on the toolbar to the left of the workspace. Click and hold the left mouse button down on the NE where the connection is originating and drag to the destination NE. A line is drawn between the two NEs as the crosshair pointer progresses. Refer to Figure 708-2.

2.The Cellworx Vision Connection Configuration window appears displaying all NEs discovered in the network in both the top section and the bottom section of the window. Refer to Figure 708-3. Ensure the originating and destination NEs are highlighted, if not, select them using the left mouse button.

3.Enter an identification for the connection in the Connection Name text box using any alphanumeric and special characters. This ID should be unique in character so the user can discern between it and other connections for management purposes. The IDs assigned here will be displayed when viewing connections. System will allow duplicate connection names but will also assign a unique ID to the connection if the user does not enter one.

Page 2-81

© 2000, ADC Telecommunications, Inc.