ADC Release 3.1 user manual SET 622 Ring Interface Card RIC Configuration

1152700 • Issue 1 • February 2001 • Section 2 Operation and Maintenance

DLP-751

Page 1 of 3

SET 622 RING INTERFACE CARD (RIC) CONFIGURATION

Summary: This procedure details the steps required to set the 622 Ring interface card configurations utilizing the Cellworx STN Phase 3.1 shelf level Graphical User Interface (GUI). User must the have GUI launched and accessed the shelf level GUI display per NTP-006 prior to performing this procedure.

1.Double click on the 622 RIC located in slot 16 or 17 in the shelf level GUI “Chassis View”at the top of the window.

2.The 622 RIC display appears as shown in Figure 751-1. The Administrative State of the card and port should be “Unlocked” if in service and cannot be set using the GUI. If two RICs were set to “Locked”, the node could be isolated requiring a complete ring turn up.

3.Set the rest of the configuration options for the card and port using Table 751-1 for descriptions of the options.

4.Select the Apply button at the bottom of the window to send the new configuration data to the shelf controller.

Note: Selecting Chassis View will return the user to the previous window without closing the 622 RIC window. Selecting Refresh will update the current window display and all the selections last recorded by the Shelf Controller card. Selecting Close will close this window.

5.Repeat steps 1 through 5 the second 622 RIC card installed in the shelf.

Stop! You have completed this procedure.

Page 2-234

© 2000, ADC Telecommunications, Inc.