NTP-004
Page 1 of 1
ADD A SECOND NETWORK ELEMENT TO AN
TERMINAL TO CREATE A RING NETWORK
Summary: This procedure describes the steps required to add a new Cellworx STN node to an
1.Verify the new node is powered on. If not, perform power on
procedures at the location. |
2.Verify the new node has the required RIC cards physically installed and fibers are connected. Refer to the Cellworx
| Installation manual listed in the preface of this document for |
|
| card installation or use the fiber procedure to install fibers. | |
3. | Launch the Cellworx Vision GUI from the | |
4. | If an abnormal GUI session ending occurred from operator error, |
|
| time out, or other unforeseen events, it might be necessary to |
|
| free up the GUI and log back in. | |
5. | If adding a node to a SAM to form a ring, change the shelf type |
|
| (from a 6 to a 1) to a ring node via the thumbwheel switch on |
|
| the SC terminating EIM (TEIM). It can be located at the rear of |
|
| the shelf in slot 18. Refer to the Phase 3.1 Cellworx Installation |
|
| Manual listed in the preface of this document. Otherwise, go to |
|
| step 7. | 1152693 |
6.Verify the RICs are installed in the SAM node and then perform a hard reset on the SCs so they will read the new shelf type. This
will be traffic affecting. |
5.Add the Cellworx STN shelf to the standalone node. The shelf
| IDs of the new node should have been set during installation and |
|
| recorded on the label provided on the inside of the front door |
|
| panel. | |
6. | Configure the node parameters. | |
7. | Perform acceptance tests on the new node. | |
8. | Add an expansion shelf to the new node if equipped. | |
9. | Save the NMIC database. |
Stop! You have completed this procedure.
Page
© 2000, ADC Telecommunications, Inc.
