
1152700 • Issue 1 • February 2001 • Operation and Maintenance
DLP-790
Page 3 of 14
configured. The quantity of VCIs selected must match the Root VCI quantity or an error message will appear asking the user to select the same quantity of VCIs selected at the root endpoint.
13.Click on the Update Leaf button to configure the leaf endpoint. The Leaf interface in the first box will now have the asterisks before the definition string showing it is already configured. It should now be observed in the Configured Leaf Interface box. If a leaf was misconfigured, highlight it in the Configured Leaf Interface box and click on Reset Leaf to remove it and start over, otherwise, select the next leaf interface to configure. When selecting the VCIs for the second and consecutive leaf endpoints, the VCI numbers must be identical (ex. al leaves use VCI numbers 32 through 36 on a
14.Once all the Leaf interfaces are configured, select the Next button to continue
Note: If the user tries to select the Next>>button before configuring all the leaf interfaces, an error message appears.
15.The next window appears and allows the user to create a VCI “translation” from the Root to the Leaf Endpoint. Refer to Figure
16.Select the >> button to map the VCIs and verify they are moved to the Selected Translation box to the right. The user may opt not to mix the VCI translation by just selecting the >> button multiple times to move each VCI to the translation box for a one to one match up. If the VCIs desired are not displayed, the user may use the <<Previous button at the bottom of the window to return to the previous configuration screen to reallocate the VCI numbers being utilized.
17.Once all VCIs are mapped in the Selected Translation box, use the left mouse button to select the Next>> button at the bottom of the window.
18.The next screen appears allowing the user to specify the usage information (NDC) and service provider information for each VCI. Refer to Figure
19.Select the Segment Endpoint and Ingress NDC boxes if desired. Refer to Table
20.Select a Leaf Interface from the list provided at the lower half of the window. Select the Root VCI being configured by left mouse clicking on the down arrow and selecting a VCI from the list.
21.Select the configuration options as needed for the VCI using Table
Page
© 2000, ADC Telecommunications, Inc.