Cisco Systems VPN 3002 Refresh, VPN Client Type, Bootcode Rev, Software Rev, Up Since, RAM Size

Chapter 13 Monitoring

Monitoring System Status

Refresh

To update the screen and its data, click Refresh. The date and time indicate when the screen was last updated.

VPN Client Type

The type, or model number, of this VPN 3002 hardware client.

Bootcode Rev

The version name, number, and date of the VPN 3002 bootcode software file. When you boot or reset the system, the bootcode software runs system diagnostics, and it loads and executes the system software image. The bootcode is installed at the factory, and there is no need to upgrade it. If an engineering change requires a bootcode upgrade, only Cisco support personnel can do so.

Software Rev

The version name, number, and date of the VPN 3002 Hardware Client system software image file. You can update this image file from the Administration Software Update screen.

Up Since

The date and time that the VPN 3002 was last booted or reset.

RAM Size

The total amount of SDRAM memory installed in the VPN 3002.

Disconnect Now

Disconnects the tunnel.

Connect Now

Connects the tunnel.

Assigned IP Address

The IP address assigned to the VPN 3002 by the central-site VPN Concentrator when PAT mode is enabled. This field is not displayed when the VPN 3002 is running in Network Extension mode, because the central-site VPN Concentrator does not assign an IP address to the VPN 3002 in Network Extension mode.

VPN 3002 Hardware Client Reference

OL-1893-01 13-9