Cisco Systems VPN 3002 Command-lineInterface Errors, A-10, Problem, Possible Cause, Solution

Appendix A Troubleshooting and System Errors

Command-line Interface Errors

Command-line Interface Errors

These errors may occur while using the menu-based command-line interface from a console or Telnet session.

Table A-9 Command-Line Interface Errors

Error	Problem	Possible Cause		Solution
ERROR:-- Bad IP	The system expected a	•	You entered something other	At the prompt, reenter a valid
Address/Subnet Mask/Wildcard	valid 4-byte dotted		than a 4-byte dotted decimal	4-byte dotted decimal number.
Mask/Area ID	decimal entry, and the		number. You might have
	entry was not in that		omitted a byte position, or
	format.		entered a number greater
			than 255 in a byte position.
		• You entered 0.0.0.0 instead
			of an appropriate address.
ERROR:-- Out of Range value	The system expected a	•	You entered a letter instead	At the prompt, reenter a
entered. Try again.	number within a		of a number.	number in the appropriate
	certain range, and the	•	You entered a number	range.
	entry was outside that
			greater than the possible
	range.
			menu numbers.
ERROR:-- The Passwords do not	The entry for a	•	You mistyped an entry.	At the Verify prompt, reenter
match. Please try again.	password and the entry	•	You entered either a	the password. If the original
	to verify the password			password is incorrect, press
			password or verify entry, but
	do not match.			Enter and reenter both the
			not the other.
				password and the verification
				at the prompts.

VPN 3002 Hardware Client Reference

A-10 OL-1893-01