Cisco Systems WVC2300 manual Wired and Wireless Modes, Moving the Camera to Another Network

Installing the Camera Software	5
Wired and Wireless Modes

Wired and Wireless Modes

NOTE This section applies to the Cisco WVC2300 camera.

After the initial configuration, you can use the camera in one of two modes: wired or wireless. Verify the mode you are in by viewing the LEDs. You cannot use the camera in both modes simultaneously.

To switch between wired and wireless modes, see “Moving the Camera to

Another Network” on page 32.

Moving the Camera to Another Network

NOTE This section applies to the Cisco WVC2300 camera.

When you move the camera from a wired network to a wireless network, or vice versa, you must power off the camera before connecting to the new network.

To move the camera from a wired network to a wireless network, follow these steps:

STEP 1 Unplug the power adapter from the camera.

STEP 2 Unplug the Ethernet network cable from the camera.

STEP 3 Re-connect the power adapter to the Power port on the camera. The camera’s Ready LED flashes while the camera is initializing. The camera is ready for use when the Ready and Network LEDs are solidly lit.

Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide 32