— 12 —
3.2 Part Descriptions(1) I/F connector Printer can be connected to the signal line of various kinds
of host via a cable. Please ensure that both the printer and
the host are turned off before connecting or disconnecting.
This connector also has a power input.
Connect the FG terminal to the earth.
Cable connected differs with the interface.
(2) FEED switch Paper is fed while this switch is pressed and held.
Turning the printer power on while pressing and holding
this switch causes self-printing to start.
In the memory switch setting mode, various kinds of setting
are available by pressing this switch.
(3) Power lamp Lights/blinks when the paper has become scarce or run out.
The lighting status depends on the memory switch setting.
Blinks when mechanism error or the like occurs depending
on the condition of memory switch setting.
(4) Knob Used to set paper or to open the front cover when setting
or replacing paper.
(5) Ribbon cover Opened/closed when replacing the ink ribbon cassette. Can
open when you pull the left side of the front face toward
you.
(6) Paper holder Printing paper is set and fixed here.
Insert the print paper into the paper inlet and then set the
paper.
(7) PE sensor Detects no paper condition.
(8) PNE sensor Detects paper-low condition.
This function is enabled or disabled depending on the mode
or memory switch setting.
(9) DIP switch (SW1) This switch allows basic initial setting.
Use this switch before turning on the printer.
(10) Back switch Press this switch to use special function.
This switch is not used in normal operation.
(11) POWER lamp Lighted when power is turned ON. Blinks at the occurrence
of error or during memory switch setting.
(12) Mounting bracket A bracket to hold the printer body.
Hold the printer to the panel or the like by using the two
screws supplied.
(
Interface connector
)