(9)Sentence Registration (ESC + “/”) Command
With input of ESC (1BH) + “/” (2FH) + n + ‘registered’ + CR (0DH) / LF (0AH) code, 24
With any other numeral having been set, data following is regarded as print data, where no registration takes place and printing conducted.
Data cannot exceed one line and must be ended with CR (0DH) or LF (0AH).
To register a statement exceeding one line, the statement up to 24 (40) bytes is registered and the data following is printed out as print data.
The ESC command cannot be registered.
The registered data is cleared when the printer is turned off.
(10)Registered Sentence Printing (ESC + “!” ) Command
With ESC (1BH) + “!” (21H) + n code input, the statement already registered in the numeral assigned to n is printed.
Assign, to n, a numeral of 1 to 8. With any other numeral having been set, no execution takes place.
Note 1: As much as 24 (40) bytes of data can be registered. In case that 24 (40) columns are exceeded on printing (because of enlarged or ⋅4 letters having been assigned, etc.), printing is conducted up to 24 (40)th column and the columns overflowed are printed in the next line. Be sure to make registration in consideration of printing results.
Note 2: When double height and width character printing or inverted character printing is executed in registered sentence printing, this setting is active even after returning to normal printing unless that setting is cancelled.
[Application Example] | [Registered State] |
ESC | / | 1 | This is a pen | CR | ||
Registered in 1. |
|
|
|
| ||
|
|
|
|
|
|
|
ESC | / | 9 | It this a pen ? | CR | ||
No registration made with 9. |
|
| ||||
|
|
|
|
|
| |
ESC | / | 1 | Is this a pen | CR |
| |
Overwritten on sentence registered initially in 1.
ESC ! 1
1It is a pen
2
3
4
5
6
7
8
Printing of sentence registered in 1.
[Printing Result]
(Printed without registration)
(Printed with ESC+!+1)
— 40 —
