MAKING A COMPOUND (BEVEL) MITER CUT
Sea Figure 50.
Practice on scrap wood. From the front of the sew, push the wood to the blade with the miter gage. Do not use the rip fence.
WARNING: Make sure the blade guard is lowered over blade and is workingproperly to
prevent possible injury.
•Set the blade angle and height by looseningthe bevel lock handle and turningthe heightand bevel handwheeis. Retightenthe bevel lock handle.
COMPOUND(BEVEL)MITERCUT
WHENMITERGAGEISPLACERIGHTHAND
ONRIGHTSIDEOFBLADEONWORK,PIECEAND
PLACELEFTHANDONMITERGAGEHERE MITERGAGEKNOBHERE
,_ WARNING: When blade is angled to the left, the miter gage must be on the dghtside of the
blade. Otherwise the gage could trap the workpiece, possiblycausing kickback and resulting in injury.
•Set the wood angle by loosening the miter gage knob and settingit to the desired angle.
•Retighten miter gage knob.
•Place a supportthe same height as the top of the saw table behind the saw for the cut work.
Fig. 50
II Make sure the wood is not touchingthe blade.
•Insert the kay and lift the switch to the ON position. Let the blade build up to full speed.
•Hold the work firmly against the miter gage and push the miter gage to feed the work intothe blade.
•When the work is completed,press the switch off and remove the key.
CRRFTSI4RN"TABLESAW315.22831038
