PROBLEM
Sawdoesnotstart.
CAUSESOLUTION
1.Motorcordorwallcordisnot 1. Pluginmotorcordorwallcord. pluggedin.
2. | Circuitfuseisblown. | 2. | Replace circuitfuse. |
3. | Cimuitbreakeristripped. | 3. | Reset circuit breaker. |
4. | Cordorswitchisdamaged. | 4. | Have the cord or switch re- |
|
|
| placed at your nearest Sears |
|
|
| Service Center. |
Sawisnoisywhenrunning.
Motorissloworweak.
Motoroverheats.
Motorstalls,blowsfuses,ortrips
circuitbreakers.
1.Motor needs attention.
1.Voltage from source is low.
2.Windings are burnedout or open.
3.Start switchis defective.
4.Circuit is overloaded with appliances, lights, or other motorS.
1.Motor is overloaded.
2.Du$$blade.
3.Sawdust inside saw is blocking air flow.
1.Starter switch is defective.
2.Voltage from source is low.
3.Dull blade.
4.Fuses or circuit breakers are wrong size or defective.
5, Feeding workplace too rapidly,
1.Have the motor checked at your nearest Sears Service Center.
1.Request a voltage check from the power company.
2, Have the motor checked at
your nearest Sears Service Center.
3, Have the switch replaced.
4.Do not use other appliances or motors on the same circuit
when using the saw.
1.Request a voltage check from the power company.
2.Replace the blade.
3.Clean out the saw base.
1.Have the switch replaced.
2.Request a voltage check from the power company.
3.Replace the blade.
4.Replace fuses or circuit breakers.
5.Feed work,piece into blade slower.
CRIIFTSNRN"TABLESAW315.22831042
