Dell T105 Systems owner manual Installing System Components

5Install the memory modules in the same sockets from which they were removed. See "Installing a Memory Module" on page 77.

6Install the expansion cards and connect any cables. See "Installing an Expansion Card" on page 72.

7Depending on your configuration, connect the following cables that you removed in "Removing the System Board" on page 100. See Figure 6-2.

•Two power-supply cables to the POWER and POWER12V1 connectors

•If applicable, diskette data cable to the FLOPPY connector

•I/O panel cable to the CONTROL-PANEL connector

•Processor cooling fan cable to the FAN1 connector

•Card cage cooling fan cable to the FAN2 connector

•SATA hard-drive data cable(s) to the SATA connector(s)

•Intrusion switch cable from the INTRUSION connector

8Close the system. See "Closing the System" on page 47.

9Reconnect the system to the electrical outlet, and turn on the system.

102

Installing System Components