Dell T105 Systems Troubleshooting a Wet System, Liquid spilled on the system Excessive humidity

3Ensure that the appropriate drivers are installed and the protocols are bound. See the NIC's documentation.

4Enter the System Setup program and confirm that the NICs are enabled. See "Using the System Setup Program" on page 31.

5Ensure that the NICs, hubs, and switches on the network are all set to the same data transmission speed. See the network equipment documentation.

6Ensure that all network cables are of the proper type and do not exceed the maximum length.

If the problem persists, see "Getting Help" on page 137.

Troubleshooting a Wet System

Problem

•Liquid spilled on the system.

•Excessive humidity.

Action

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 47.

3Remove all expansion cards installed in the system. See "Removing an Expansion Card" on page 70.

4Let the system dry thoroughly for at least 24 hours.

5Close the system. See "Closing the System" on page 47.

6Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.

If the system does not start properly, see "Getting Help" on page 137.

Troubleshooting Your System

109