Dell T105 Systems Has occurred Diagnostics. See, Dimm configuration Reinstall the memory, Again

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
Warning! A fatal error	A multibit ECC error	Run the system
has caused system	has occurred.	diagnostics. See
reset!		"Running the System
Please check the system		Diagnostics" on
		page 127.
event log.
Warning: The installed	A DIMM configuration	Reinstall the memory
memory configuration is	is unsupported. The	modules and, if
not optimal.	installed memory	necessary, replace them.
	modules are not	See "Troubleshooting
	matched pairs.	System Memory" on
		page 114.

Write fault

Write fault on selected drive

The operating system cannot write to the diskette drive or hard drive.

See "Troubleshooting a Diskette Drive" on page 116 or "Troubleshooting a Hard Drive" on page 120.

<drive letter>:\ is not	The diskette drive	Insert a diskette into the
accessible. The device	cannot read the	drive or replace the
is not ready.	diskette.	existing diskette, and try
		again.

Warning Messages

A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before you format a diskette, a message will warn you that you may lose all data on the diskette. Warning messages usually interrupt the task and require you to respond by typing y (yes) or n (no).

NOTE: Warning messages are generated by either the application or the operating system. For more information, see the documentation that accompanied the operating system or application.

About Your System

29