129
Advanced Setup – Part 2
3Press the CURSOR DDor HHbutton to select
“Surr. Sp.”, then press the CURSOR FFor GG
button to select the surround speaker(s) from
which you want to produce the test tone (A, B
orA+B).
Surr. Sp. : A
Adjusts the balance of the playback level between
the channels when using surround speaker A.
Surr. Sp. : B
Adjusts the balance of the playback level between
the channels when using surround speaker B.
Surr. Sp. : A + B
Adjusts the balance of the playback level between
the channels when using surround speakers A and
B at the same time.
The “Surr. Sp.” can only be selected when both
surround speakers A and B have been selected at the
System Setup Menu (when both A and B have been
set to “Large” or “Small”).
4Press the CURSOR DDor HHbutton to select
“Test Tone Start”, then press the CURSORFF
button to select “Yes”.
5
-1
When “Auto” mode is selected:
Press the CURSOR FFor GGbutton to adjust all
the speakers to the same volume.
•The test tones are emitted from each speaker in the
following order, at 4 seconds intervals the first time
and second time around, 2 seconds intervals the
third time around and on:
The volume can be adjusted between –12 dB and +12
dB in units of 0.5 dB.
5
-2
When “Manual” mode is selected:
Press the CURSOR DDor HHbutton to select the
speaker, then press the CURSORFFor GGbutton
to adjust all the speakers to the same volume.
Example: “Manual” mode is selected.
6Press the ENTER button to enter the setting.
•The “Channel Level” screen reappears.
FL
SW
1spkr
2spkrs
CFR SR
SBL
SL
SB
SBR
When the surround back speaker setting is set to
“1spkr” for “Speaker Configuration”, this is set to
“SB”.
Example: When the volume is set to –11.5 dB while
the test tone is being produced from the
Front L ch speaker
•To cancel the settings, press the CURSOR FFbutton to select
“Level Clear” and “Yes” on the “Channel Level” screen,
then make the settings again.