Denon AVR-4806CI operating instructions 6, 8, 7

136
Advanced Setup – Part 2
Check the parameter
1Press the CURSOR DDor HHbutton to select
“ParameterCheck” at the “Auto Setup / Room
EQ” menu, then press the ENTER button.
•Display the “Parameter Check” screen.
•The results of the measured items can be checked.
•The EQ parameters that were set in Auto Setup can be
checked.
•This item is displayed, after the measurement result of the
“Auto Setup / Room EQ” is decided.
2Press the CURSOR DDor HHbutton to select the
items, then press the ENTER button.
•Display the verification screen.
For instructions on checking the results of each item
(page 24).
3Press the CURSORDDorHHbutton to select “EQ
Parameter Check”, then press the ENTER
button.
•Display the “EQ Parameter Check” screen.
4Press the CURSOR DDor HHbutton to select the
Equalizer curve, then press the ENTER button.
•Display the “EQ Check” screen.
The display is only an approximate picture of the
response and that correction is happening at all
frequencies.
5Press the CURSOR FFor GGbutton to select the
speaker channel.
6If the check ends, pressing the CURSORDDorHH
button to select “Exit”, then press the ENTER
button.
•The “EQ Parameter Check” screen reappears.
7Press the CURSOR DDor HHbutton to select
“Exit”, then press the ENTER button.
•The “Parameter Check” screen reappears.
The results of the “Auto Setup” procedure can
be reset even if the settings have been changed
after performing the “Auto Setup” procedure:
Press the CURSOR DDor HHbutton to select
“Restore Yes
0 ”, then press the CURSOR FF
button.
8