39
Connecting Other Sources

Connecting the CONTROL terminals

These terminals are used for an external
controller.
Perform the following operation before using
an external controller connected to the RS-
232C terminal:
1. Press the ON/STANDBY button on the
main unit and set the unit to the
operating mode.
2. Perform the operation to turn off the
power from the external control.
3. Check that the product has been set to
the standby mode.
After checking the above, check the
connections of the external controller.
Operation is possible.

Connecting the XM terminal

•AVR-4806CI is the XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM Passport System (sold
separately) and subscribing to the XM service.
•Plug the XM Passport System into XM terminal on the rear panel.
•Position the XM Passport System near a south-facing window to receive the best signal.
For details, see “XM Satellite Radio” ( page 71, 72).
When making connections, also refer to the operating instructions of the XM Passport System.

XM Passport System

MX
NOTE:
•Keep the power supply cord unplugged until the XM Passport System connection has been completed.
•The XM name and related logo are registered trademarks of XM Satellite Radio Inc. All rights reserved.
•XM Ready is a registered trademark of XM Satellite Radio Inc. All rights reserved.