87
Advanced Operation
¢Using the system call function
1Press the AMP button to select the SYSTEM
CALL mode.
2Press the SYSTEMCALL button (1 to 3) at
which the system call signals have been stored.
•The stored signals are transmitted successively.
Punch Through
•Buttons used in the CD, DVD, and VCR modes can be
assigned to the buttons which are not normally used in the
TV and SAT/CBL modes.
•For example, when the DVD mode is set to the punch through
mode in the TV mode, the DVD mode’s PLAY (1), STOP (2),
MANUAL SEARCH (6, 7), AUTO SEARCH (8, 9)
and PAUSE (3) button’s signals are sent in the TV mode. — ( )
1Press and hold the RC SETUP button for at
least three seconds.
•The IR segment blinks twice.
2Press the 9, 8, 4button (9 →
8→
4) to select
punch through setting.
•The IR segment blinks twice.
3Select the MODE SELECTOR button (CD, DVD
or VCR) you want to punch through.
3Press the SYSTEM CALL button (1 to 3) you
want to register the system call.
4Press the button you want to register.
•The IR segment blinks once after each button press.
The mode can be switched by pressing a MODE
SELECTOR button.
5Repeat steps 4 to register the desired buttons.
Up to 32 signals each can be stored at the SYSTEM
CALL 1 ~ 3.
6Press and hold the RC SETUP button for at
least three seconds to registerthe system call.
•The IR segment blinks twice.
NOTE:
•The remote control signals of the buttons pressed while
registering the system call signals are emitted, so be
careful not to operate the components accidentally (cover
the remote sensors, for example).
4Press the button you want to punch through
(1,2,6,7,8,9or 3).
5Repeat step 4.
6Press the MODE SELECTOR button (TV or
SAT/CBL) forwhich you want to set the punch
through.
7Press and hold the RC SETUP button for at
least three seconds.
•The IR segment blinks twice.
Setting the back light’s lighting time
1
2
3Press the NUMBER button (1to 5) you want to
adjust the lighting time (5 sec ~ 25 sec).
¢Lighting time
1:5 sec
2:10 sec (factory default)
3:15 sec
4:20 sec
5:25 sec
•The IR segment blinks twice as confirmation.
Press and hold the RC SETUP button for at
least three seconds.
•The IR segment blinks twice.
Press the 9, 7, 3button (9 →
7→
3) to select
Light setup.
•The IR segment blinks twice.