Cross Training Programs, U T E B U R N E R

1260OM 5/31/06 7:11 PM Page 37

Workout Programs (continued)

Display

•When warm up mode is completed, the console will detect if there is a valid pulse before starting this problem.

–If there is none, this program will not be started. The messages display will scroll “ NO VALID PULSE”, and “CHECK YOUR PULSE SENSOR” until there is valid pulse.

–If there is a valid pulse, this program will be active. The message display will turn into workout data display and display four default data: time, % Max HR, calories & pulse.

•Press “Select” button under each group to select your desired data display.

Adjustment

•Press “Level Up/Down” key will do nothing to this program since the % Max HR is set at 80%; and this program automatically controls the resistance.

•Press “Incline Up/Down” key to adjust the incline level from L1 to L10. The dot matrix window will update the incline profile accordingly.

•Personal Trainer program – Personal Trainer program cannot be active during Cardio program. See Personal Trainer program section for details.

•HR Lock program – Press “HR Lock” key to switch to a new target HR program. See HR Lock program section for details.

Ending the Program

•When program time is up or Stop key is pressed, this program will end and Cool Down will be active.

•The message display will flash a message “PROGRAM END”&”COOL DOWN”. See Cool Down mode for details.

•“Start” key could be pressed to re-start the Cardio program again.

•“Stop” key could be pressed to skip the cool down and active the Workout Summary immediately.

Pause, Reset, Switch or Save a program

See Console Operating Tips section for details, pages 9 & 10.