1260OM 5/31/06 7:11 PM Page 9
Assembly Instructions
Step 1: Rear Stabilizer Bar
1.Place rear stabilizer bar under rear mainframe and align the screw holes.
2.Insert and tighten these two (M8 x 16mm) screws, split lock washer and flat washers using 6mm Allen wrench.
Step 2: Console Mast Assembly
1.Slide console mast cover onto console mast, making sure it is facing the right direction.
2.Connect the plug to the plug receptor of the main wire harness inside the console mast, taking care to install correctly. (See plug alignment marks)
3.Install the console mast by carefully sliding it onto the console mast receptor while pulling the wire harness. This will keep the slack out of the harness so that the wires will not be pinched and short out.
HINT: Pay attention to the wire harness while sliding the console mast and do not pinch the wire harness. Failing to do so will result in a void warranty.
4.Insert the four screws (M8 x 16mm), spring washer and washers into console mast and hand tighten them. Note: do not tighten them until you have all 4 sets of screws, split lock washers and flat washers inserted. Finally, tighten all of them with attached 6mm Allen wrench.
5.Place console mast cover in place and align it with snap holes. Snap the console mast cover into main side cases, making sure all snaps are in place.
6.Insert and tighten console mast cover with two screws (M5 x 12mm) using a Phillips screwdriver.
7.Peel the rubber mats and place them on the accessory trays.
Step 3: Handlebar Assembly
1.Insert the hand pulse harness through the opening of the console mast and out the top of the console mounting plate.
2.Assemble the handlebar onto the mount and insert and tighten four screws (M6 x 12mm), split lock washers and flat washers using 4mm Allen wrench. Be sure not to pinch the hand pulse wire harness during this procedure, as this will damage the electronic console.
Step 4: Console Assembly
1.
WIRING HARNESS INSTALLATION HINT: Any excess wiring must be carefully inserted (stored) back into console mast before installing the console onto the console mounting plate.
2.Fasten the console to the console mounting plate with four (M5 x 12mm) screws using a Phillips screwdriver.
Step 5: Handrail Assembly
1.Insert Right handrail (See “R” mark on the mounting plate) into handrail receptor and align the screw holes of two mounting plates.
2.Insert and tighten four (M6 x 12mm) screws, split lock washers and flat washers with attached 4mm Allen wrench.
3.Install the handrail cover by tighten two (M5 x 8mm) screws using a Phillips screwdriver. Make sure the oblong opening is facing up and on the handrail side.
4.Repeat this assembling process for the Left handrail and its cover.
Step 6: Power Cord
1.Place the elliptical equipment on a solid, leveled floor.
2.Plug the power cord into a wall outlet and turn the power switch ON.
1260Ef Owner’s Manual | 5 |
|
|
