1260OM 5/31/06 7:11 PM Page 44
User 1 & User 2
key
Workout Programs (continued)
USER 1 & USER 2
Getting Started
These programs are designed to be
Save a program into User 1 or User 2
To save your favorite program into User 1 or User 2, press & hold “User 1” or “User 2” for 2 seconds during anytime of a program.
•The message display will scroll a message of “YOUR PROGRAM HAS BEEN SAVED” to indicate the success of saving the program. After this message, the console will resume to previous activities.
•Following information of this program will be saved:
–Age & Weight
–Program time
–Intensity & incline, difficulty level, profile
–HR setting if it is a HR Interactive program
•If there was a program saved in the User 1 or User 2 before, the new program will overwrite the pervious program.
Select User Program and Beginning the Program
To select a User program, press “User 1” or “User 2” key once anytime during idle mode. Its LED indicator will turn on.
•If there was no saved program, the message display will scroll, “NO SAVED PROGRAM, SELECT ANOTHR PROGRAM” and wait for an instruction.
•If there was a saved program, the dot matrix will display the program profile; the messages display will flash a message “USER 1” or ‘USER 2” and scroll
“PRESS ENTER TO ADJUST OR START TO BEGIN”.
•Press “Start” key to accept current default values and begin Interval program workout.
•Or press “Enter” to enter program setup mode. The message display will take you through the program setup mode step by step as below:
–Entering Time
–Other entry if necessary.
During the Program
Once Start key is pressed, the Warm Up will be active. See Warm Up mode section for details.
Display:
When warm up is completed, the console will start
40 | 1260Ef Owner’s Manual |
|
|
