DMP Electronics XR500 manual 19.10.3 19.10.4 19.10.5 19.10.6 19.10.7 19.10.8, LED Operation

Zone Information

19.10.3

19.10.4

19.10.5

19.10.6

19.10.7

19.10.8

TRANSMTR CONTACT 1 2 3 4

ALREADY IN USE ZONE NUMBER: XXX

zone information norm opn no yes

TRANSMITTER SUPRVSN TIME: 240

SELECT MINUTES:

0 3 60 240

LED OPERATION NO YES

DISARM DISABLE NO YES

wireless pir pulse count: 4

wireless pir sensitivity:low

NEXT ZONE no yes

This option displays when programming the 1114 Wireless Four-Zone Expander

with four input contacts. The same serial number is used for all four contacts.

Select the contact number to program. When using the contacts, you must use consecutive zone numbers. Default is Contact 1.

For example, use serial number 08345678 to program Contact 1 for Zone 561, Contact 2 for Zone 562, Contact 3 for zone 563, and Contact 4 for zone 564.

A tamper on the 1114 is transmitted as the zone number assigned to Contact 1.

This message displays when the Contact is already programmed for another zone. The programmed zone number displays.

This option only displays when EXT is selected as the Contact type. For external devices connected to the 1101 or 1103 terminal block, select NO to use normally closed (N/C) contacts. Select YES to use normally open (N/O) contacts. Default is NO.

Supervision Time

Press any top row key to select the supervision time required for the wireless

zone. Press COMMAND to accept the default time. Default is 240 minutes.

Note: Refer to the Wireless Check-in and Supervision Time Definitions section of the Appendix for supervision information.

Press the Select key under the required number of minutes. The transmitter must check in at least once during this time or a missing condition is indicated for that zone. 1100 Series transmitters automatically checkin based on the supervision time selected for the wireless zone, no additional programming is needed. If two zones share the same transmitter, the last programmed supervision time is stored as the supervision time for both zones. Zero (0) indicates an unsupervised transmitter.

Note: When the panel is reset or a receiver is installed or powered down and powered up, the supervision timer restarts for all wireless zones.

LED Operation

Select YES to turn on an 1142 Hold-up transmitter LED during Panic or Emergency operation. Select NO to turn the LED off during Panic or Emergency operation. The LED always operates when the transmitter case is open and the tamper is faulted. Default is YES.

Disarm/Disable

Select YES to disable the zone tripped message (short) to the 1100X Series Receiver from the 1126 PIR transmitter during the disarmed period. When disabled, the 1126 only sends supervision, tamper and low battery messages during the disarmed period to extend transmitter battery life. Select NO to always send zone tripped messages in addition to supervision, tamper and low battery. Default is YES.

PIR Pulse Count

Select the number of infrared pulses (2 or 4) the 1126 PIR should sense before

sending a short message to the 1100X Series Receiver. Default is 4.

PIR Sensitivity

Select the sensitivity setting for the 1126 PIR. Selecting LOW sets the 1126 to operate at 75% sensitivity for installations in harsh environments. Selecting HIGH sets the PIR to maximum sensitivity. Default is LOW.

Next Zone

Select YES to return to the ZONE NO: - prompt to program a new zone. Select

NO to display the Alarm Action option.

Digital Monitoring Products XR500 Series Canadian Programming Guide

52