Feature Upgrade
Feature Upgrade
22.1
22.1.1
22.1.2
FEATURE UPGRADE
ENTER KEY
-
ENCRYPTION
DISABLED
ALL NO YES OPTN
DISABLED
Feature Upgrade
In the Programming Menu, pressing COMMAND at the SET LOCKOUT CODE prompt displays FEATURE UPGRADE. This allows you to enable additional features in the panel. Press any top row Select key to display the first available feature. ENABLED or DISABLED displays indicating whether this feature is currently used in this panel. Press the COMMAND key to display additional feature(s).
To enable a feature, press any top row Select key anywhere in the features list to display the ENTER KEY prompt.
Enter the
Note: XR500 Series version 106 or higher panels require a six (6) character feature key. Version 105 panels require a
If the feature key entered is not accepted, the ENTER KEY prompt displays again.
Encryption
Enable this feature to provide 128 bit AES data encryption. This feature upgrade can only be enabled on an XR500N panel version 105 or higher. For installations where an XR500 panel is installed, it is recommended the XR500 be replaced with an XR500E panel.
To complete encryption installation, access System Status in the User Menu to verify the encryption status (ON or OFF). If the status displays OFF, it indicates that the Passphrase has not been entered and data transmissions are not encrypted. See Network Options to set up a Passphrase.
All No Yes Option
This feature offers the ability to disable the ALL NO YES option at arming or disarming. When this feature is enabled, the ALL NO YES option does not display at any system keypad during arming or disarming. Each area assigned to the user profile is chosen to be armed or disarmed independently.
22.1.3
SVC USER AUTH
DISABLED
Service User Authentication
This feature offers the ability to authenticate service personnel before allowing access to panel programming or performing any user operations. When this feature is enabled and a valid Service User code is entered for system operation or 6653 is entered for programming, the Service Code entry option displays.
When the service person enters the Service Code, the panel authenticates the code with the Service Code preprogrammed in the
Note: The Service User code is user number zero (0) and can only be created in the panel remotely. The
Purchasing Feature Upgrades
To purchase a feature upgrade, you may contact DMP Customer Service with the feature you would like to enable and the panel serial number. The serial number(s) should be sent in writing via
The panel serial number can be located several different ways:
•Printed on a label located on the right side of the XR500 PCB.
•Using panel diagnostics. See the Appendix.
•Using Remote Link™ (version 1.18 or greater). See the Remote Link User’s Guide
—Initial Panel Connection screen
—System Information screen.
XR500 Series Canadian Programming Guide | Digital Monitoring Products |
61