STOP
20.1Stop
Stop
Stop
Save Programming
WHEN ANY PANEL PROGRAMMING IS CHANGED, THE STOP ROUTINE MUST BE RUN AND ‘SAVING PROGRAM’ MUST DISPLAY ON THE KEYPAD IN ORDER TO SAVE THE PROGRAMMING CHANGES.
At the STOP prompt, pressing any Select key allows you to exit the Programmer function of the panel. When selected, the panel performs an internal reset and exits the programmer.
The STOP routine causes the following conditions to occur:
•All 1100 Series DMP Wireless transmitters are reset to NORMAL
•The panel Status List is cleared
During the reset, all keypad displays are momentarily blank for two seconds. After the reset, the programming function terminates and the keypads return to the status list display.
The STOP prompt does not disarm the system. Any new areas or zones that were added during programming are not armed until the system is disarmed and armed again.
Missing LX-Bus™ Modules Displayed
The Programmer includes a feature following the STOP routine that displays the name of any programmed
Keypad Display | Missing Card |
NO LXBUS CARD | 481 |
NO PRINTER CARD | 462P Printer Interface Card |
NO HOST CARD | 462N Network Interface Card |
| (with NETWORK communication selected) |
The above messages clear automatically from the keypad after a few moments.
Power Up
When the XR500 Series Canadian panel is powered up after an AC power failure, any zone transitions are not recognized for 120 seconds. Normal zone processing resumes at the end of the 120 seconds.
Set Lockout Code
Set Lockout Code
21.1
Set lockout code
Set Lockout Code
Pressing COMMAND at the STOP prompt displays SET LOCKOUT CODE. This allows you to program a code that is then required to gain access to the panel internal Programmer through the keypad. You can change this code at any time to any combination of numbers from three to five digits long. You do not need to enter leading zeros when using the lockout code. Initializing the panel does not clear a Lockout Code. Lockout Codes can be changed through Remote Link.
Once you have changed the code, it is important to write it down somewhere and store it in a safe place. Lost Lockout Codes require the panel to be sent back to DMP for repair. You may cancel a Lockout Code by entering 00000 at the Set Lockout Code command.
Lockout Code restriction
Do not set a Lockout Code higher than 65535.
Digital Monitoring Products | XR500 Series Canadian Programming Guide |
60