Dolphin Peripherals 9500 manual Using the Dialer, Receive Contact or File, Enable File Sharing

Exit Bluetooth File Explorer

To exit the Bluetooth File Explorer, tap File > Exit.

Receive Contact or File

1.Tap on the Bluetooth icon. In the pop-up menu, tap Transfer via Bluetooth > Receive Contact or File.

2. The Receive Contact or File status screen appears. Your device waits two minutes for the contact or file.

3.After successfully connecting to the remote device, the screen reports Connected then disappear. The new contact or file should now be on your device.

4.If two minutes passes before you receive the item, tap Wait Again.

5.After you receive the file or contact, the “Receive Contact or File” feature is automatically disabled.

Enable File Sharing

1.Tap on the Bluetooth icon. In the pop-up menu, tap Transfer via Bluetooth > Enable File Sharing.

2.The Enable File Sharing status screen appears. Your device waits two minutes for the remote device to connect.

3.After successfully connecting to the remote device, the screen reports that you are connected.

4.If two minutes passes before you connect, tap Wait Again.

5.File sharing is enabled until you end it by tapping Cancel.

Using the Dialer

This section explains how to assign a dialing prefix and use the Dialer to dial a number directly from your Contacts list. The Dialer makes it quick and easy to perform dial-up networking.

Note: The Dialer has been verified to work with Nokia and Ericcson phones and is known not to work with the Motorola 270c, NTT Docomo Paldio 633S or Sony au C413S phone. Results may vary with other phones that are not listed as being supported by the Bluetooth system.

8 - 18 Rev C Dolphin® 9500 Series User’s Guide