Dolphin Peripherals 9500 manual Align the Screen

Step 5. Align the Screen

You are prompted to align the screen by tapping the target five times. Use the stylus provided by Hand Held Products.

•Alignment should always be performed with a stylus designed for touch screen applications. The small point is required for accurate calibration.

•Press the stylus firmly into the center of the cross-hair target once and release. Do not “double-tap” the target.

•You can re-align the screen at any time by going to Start > Settings > System tab > Screen.

Step 6. Let Autoinstall Run

For each program that loads, a status bar indicates that the program is loading. Autoinstall occurs after each hard reset. Do NOT touch the keyboard or the screen while programs are loading. All configurations of the Dolphin terminal install Demos and Power Tools. If the terminal is configured with a wireless radio, the appropriate radio drivers and utilities for each radio install.

After Autoinstall is complete, the terminal performs a soft reset automatically. When it finishes booting up after the soft reset, the Today screen appears; see Today Screen on page 4-2.

Step 7. Set the Time and Date

You need to re-set the time and date after every hard reset of the terminal. It is a good idea to set the time and date now before you begin using the device.

On the Today screen, tap the line that displays the time and date,

The Clock Settings screen appears.

The time zone defaults to GMT-5 Eastern US; tap the arrow to the right of GMT-5 Eastern US to select another time zone. Set the correct time and date in the remaining fields and tap OK to save.

Step 8. Verify Imaging and Decoding with Demos

Dolphin terminals come loaded with Demos you can use to verify imaging and decoding.

Dolphin® 9500 Series User’s Guide Rev C 2 - 9