Dolphin Peripherals 9500 manual Configuring Network Cards

Configuring Network Cards

To see the network cards installed on your terminal, tap Start > Settings > Connections tab > Connections > Advanced tab (see page 5-17) > Network Cards.

Tap on an adapter to review its settings.

Use server-assigned IP address is selected by default; server-assigned IP addresses use DHCP. If you make any changes on these tabs, you must tap OK to save the changes, then perform a soft reset to update the registry.

After you tap OK, the following message appears:

Tap OK again to save any changes.

For details about performing a soft reset, see Soft Reset (Warm Boot) on page 2-11.During the soft reset, the new registry entries created by the changes can be read by the applications that need them.

Do NOT perform a hard reset (see Hard Reset (Cold Boot) on page 2-11)after modifying an adapter here. Hard resets return the ! terminal to factory defaults.

5 - 26 Rev C Dolphin® 9500 Series User’s Guide