Dolphin Peripherals 9500 manual Supplying Power to the QuadCharger, Power Switch

Back Panel

CHARGE/ANALYZE

O

0% ALYZE

0%

4 LOT YRTTE PACITY

4

3 2

1

	Swc
Status LED	Power Switch Power Supply Connector

Power Switch

Toggle the power switch to turn the QuadCharger on and off.

Power Supply Connector

Use this connector to attach the power supply to the QuadCharger. The universal power supply accepts input voltages between 90-265 volts.

Supplying Power to the QuadCharger

The QuadCharger must be connected to a power source via the Hand Held Products power adapter cable so that voltage is adjusted appropriately.

1.Locate the AC power adapter cable and plug it into the power source.

2.Connect the power cable to the power adapter.

3.Connect the power cable to the supply connector on the back of the QuadCharger.

4.Press the power switch to the ON position.

The power LED illuminates green, and the charger performs a self-diagnostic test that lasts approximately five seconds.

Dolphin® 9500 Series User’s Guide Rev C 15 - 3