DreamGEAR MSK 33 Return Path IF Menu, Return path IF menu, IF CONTROL analog, If Measure, RP frq

Return Path IF Menu

Return path IF menu

	70
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

TV-IF38.90MHz A65.0dBµV

	70
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
RP 22.40 MHz A	65.0dBµV

ANALOG Menu

BACK

IF CONTROL

analog

>

IF MEASURE

BACK

RP frq

RP-inv off

RP CONTROL digit. DVB-C>

RP MEASURE

In this menu, the video carriers -each according to optional assignment- can be measured on IF levels (38.9 MHz analogue and 36.15 MHz digital) or on the entire return path area (Optional return path card) from 4 MHz to 80 MHz.

Each according to assignment, the MSK 33 answers with the IF menu or the optional return path menu (refer to star marking).

Entering a frequency of 7.00 MHz up to 80.00MHz*

￿￿RP frq

The return path frequency can be entered in with the numerical button, „0...9,“ with the cursor buttons, ◄►, in 50 kHz increments. The frequency is displayed in the lower left-hand corner.

Inverting the RF spectrum*

RF-inv off ￿

By pressing this button, he RF spectrum can be inverted. This mean, that the video and audio carrier for digital modulation, the I and Q vectors can be exchanged.

analog

>

DIGITAL menu

digit. DVB-C>

RP MEASURE

RP MEASURE

Access the analogue menu with the buttons, “analog” and “RP MEAS- URE.” In this menu, settings and measurements of analogue signal are possible (For further information, refer to the TV Analog menu).

Access the digital menu with the buttons, “digit. DVB-C” and “RP MEASURE”. In this menu, settings and measurements of the DVB-C signals are possible. IF demodulation if DVB-T signals is also possible (For further information, refer to the TV digital menu).

IF CONTROL menu (RP-CONTROL*)

IF (RP)

CONTROL

In this menu, all remotely controlled parameters, such as remote feeding voltage, 22 kHz, DiSEqC, tone burst (simple DiSEqC), V-SEC, can be set (for further infor- mation, refer to TV menu).

49