DreamGEAR MSK 33 manual DiSEqC Scope, Saving function, shot cont, Increasing time / unit

+ time

DiSEqC Scope

Calls up the last set menu.

Increasing time / unit

With this function, the DiSEqC signal can be compressed on the dis- play. Eight control time-

stages are available. The unit switched accordingly to the next highest stage, when the button is pressed once more. If the softkey field no longer changes colour, the highest stage is reached.

- time

Reducing time / unit

With this function, the DiSEqC signal can be stretched on the display. Eight control time-stages are available. The unit switches accordingly to the next lowest stage, once the button is pressed once more. If the softkey field no longer changes col- our, the lowest stage is reached.

Saving function

shot

cont

By pressing this button, the saving oscilloscope is set to standby. As soon as a DiSEqC signal is on the antenna socket of the MSK 33, it is recorded and saved until you either press the button again or switch over with the button „cont“ to con- tinuous recording.

Switches the oscilloscope back to continuos recording.

Position and triggering of the DiSEqC signal

With the cursor buttons, ▼▲, the vertical position of the DiSEqC signal can be changed. The trigger point, which at 14 or 18V, is then also set or changed.

With the horizontal cursor buttons, ◄►, the type of representation of the DiSEqC can be selected:

run in seq = Swing in sequence run out seq = Swing out sequence carrier = 22 kHz carrier modulation = carrier modulation

68