DreamGEAR MSK 33 manual Broadband Cable Analysis Measuring System MSK MVG

Broadband Cable Analysis Measuring System MSK 33 /

MVG

Retransmission of the spectrum received by the MSK 33 (1) with a MVG 10 (2).

It is possible to transmit the received spectrum on the head station or a FBAS sig- nal of an external unit (camera, head station computer etc.) via the MVG 10 (2) on free CATV channels. Here, the MSK 33 is connected to the MVG 10 with the fully occupied Scart cable.

Please make sure, that the MVG 10 is two-sided band modulated.

Therefore, you need two free RF channels for picture transmission.

Monitoring camera or PC-Monitoring

MSK33 Receiver (1)

ext FBAS*

Graphik

RGB

Cable system

With return path capable amplifiers

MVG10

Wobbel- generator (1)

MSK33 Receiver (2)

MVG10 (2) Signal wobbel- generator

Represenation of the upstream spec- trum on the head station Measurement of the downstream spectrum

*In case you want to additionally transmit a CVBS signal via the MVG 10 (2) in this measurement arrangement, you must change the SCART cable between MSK 33

(1) and MVG 10 (2) as follows:

￿￿Separate the cable from Pin 20 (Video in) on the SCART cable plug, which is connected with the MSK 33.

￿￿Connect a shielded 75 ohm cable with a Cinch connector on the other end on PIN 20 (Video in).

￿￿Connect the screen of the cable with PIN 17 (video earth).

The MSK33(1) converts the fed-in video signal into a RGB signal and delivery this signal for modulation on the MVG10(2).

The switching occurs via the MVG 10 (1) function Fkt B 0/1 Graphic transmission = Fkt B 1

ext. FBAS = Fkt B 0

Refer to the operating manual MVG10.

87